System information

Chapter 2 Fault Management RADview-EMS ASMi-52 User’s Manual
2-12 Repeater Level – Fault Menu
Table 2-7. Port Active Alarm List Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Port
CONTROL, ETH, SHDSL Link, E1, T1, DTE (V.35, X.21, RS-530)
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Code Alarm code
4, 5, 8, 15, 51
Note: Bits 4 and 5 are only relevant for V.35/RS-530
Note: Bit 8 is only relevant for IR-IP
Description Description of the alarm
Note: See Appendix A for a full list of alarm descriptions
Severity Major, Minor, Warning
[Close] Click <Close> to close the Active Alarm List dialog box
[Save to File...] Click <Save to File...> to save the Port Active Alarm List to a file
Note: In the File of type field, select Acrobat (*pdf) or HTML (*.htm).
[Print...] Click <Print...> to print the Port Active Alarm List
[Refresh] Click <Refresh> to update the Port Active Alarm List
2.7 Repeater Level – Fault Menu
The Fault menu allows you to display active alarms at the repeater level.
Figure 2-15. Repeater Level Fault Menu
Displaying the Active Alarms at the Repeater Level
The Active Alarms command enables you to display the active alarms at the
repeater level.

To display the active alarms at the repeater level:
1. In the RADview ASMi-52 window, select a repeater.
2. Select Fault > Active Alarms…
You can sort the Active Alarm List by clicking any of the column headings.
Note