System information

RADview-EMS ASMi-52 User’s Manual Chapter 2 Fault Management
E1 and T1 Port Levels – Fault Menu 2-9
Table 2-5. Port Active Alarm List Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Port
CONTROL, ETH, SHDSL Link, E1, T1, DTE (V.35, X.21, RS-530)
Far-End Modem
Type
Unknown, ASMi-52A, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Code Alarm code
8
Description Description of the alarm
Note: See Appendix A for a full list of alarm descriptions
Severity Major, Minor, Warning
[Close] Click <Close> to close the Port Active Alarm List dialog box
[Save to File...] Click <Save to File...> to save the Port Active Alarm List to a file
Note: In the File of type field, select Acrobat (*pdf) or HTML (*.htm)
[Print...] Click <Print...> to print the Port Active Alarm List
[Refresh] Click <Refresh> to update the Port Active Alarm List dialog box
2.5 E1 and T1 Port Levels – Fault Menu
The Fault menu allows you to display the active alarms at the E1 and T1 port
levels.
Figure 2-11. E1 and T1 Port Level Fault Menu
Displaying the Active Alarms at the E1 Port Level
The Active Alarms command enables you to display the active alarms at the E1
and T1 port levels.

To display the active alarms at the E1 and T1 port levels:
• At the E1/T1 port level (NE or FE), select Fault > Active Alarms...