System information

Chapter 2 Fault Management RADview-EMS ASMi-52 User’s Manual
2-6 SHDSL Link Port Level – Fault Menu
Table 2-3. Modem Alarm Buffer List Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Code Alarm code
1…43, 50, 51, 60…66
Description Description of the alarm
Note: See Appendix A for a full list of alarm descriptions
State
Off, On
Date The date of the alarm, in the format YYYY-MM-DD
Time The time of the alarm, in the format HH:MM:SS
[Close] Click <Close> to close the Modem Alarm Buffer List dialog box
[Save to File...] Click <Save to File...> to save the Modem Alarm Buffer List to a file
Note: In the File of type field, select Acrobat (*pdf) or HTML (*.htm)
[Print...] Click <Print...> to print the Modem Alarm Buffer List
[Refresh] Click <Refresh> to update the Modem Alarm Buffer List dialog box
2.3 SHDSL Link Port Level – Fault Menu
The Fault menu allows you to display the active alarms at the SHDSL Link port
level.
Figure 2-7. SHDSL Link Port Level Fault Menu
Displaying the Active Alarms at the SHDSL Link Port Level
The Active Alarms command enables you to display the active alarms at the
SHDSL Link port level.

To display the active alarms at the SHDSL Link port level:
• At the SHDSL Link port level (NE or FE), select Fault > Active Alarms...