Specifications

System Installation
RADring
Installation & Operation Manual
3-8 Connector Types 3/11/98 12:29
High Power
Module
1. Disconnect all power from the RADring hub and place the hub up-
side-down on a flat surface.
2. Remove the panel covering the opening for the additional power
supply. The cover is held in place by four screws.
3. Connect the Molex connector of the cord attached to the power supply
to the JP2 connector on the mother board.
4. Remove the strip tying the male Molex connector to the cable attached
to the DB-25 cable in power supply 1.
5. Before connecting the female Molex connector to the male connector,
remove the plastic protector from the male Molex connector.
6. Connect the female Molex connector (from the cord attached to the
new power supply fan), to the male Molex connector (DB-25 cable of
power supply 1).
7. Place the power supply in the enclosure opening and align the holes on
the power supply cover with the holes on the unit enclosure.
8. Fasten the cover to the enclosure using the four screws provided in the
installation kit.
9. Attach the rubber feet (provided in the installation kit) to the power
supply cover using the adhesive surface. Affix the rubber feet to match
the positions of the two rubber feet on the enclosure.
S
U
P
E
R
V
I
S
O
R
Y
P
O
R
T
S
U
P
E
R
V
I
S
O
R
Y
P
O
R
T
P
S
-
1
P
S
-
2
J
P
-
2
POWER
SUPPLY
2
POWER
SUPPLY
1
FAN
MOLEX CONNECTOR
(FEMALE)
FROM POWER SUPPLY
MOTHERBOARD
MOLEX CONNECTOR
MOLEX CONNECTOR
(MA LE)
MOLEX CONNECTOR
(FEMALE)
(MA LE)
ON MOTHER BOARD
HUB
FAN
CABLE FROM
DB25 CONNECTOR
WIRES FROM FAN
(RED AND BLACK)
J
P
3
J
P
2
Figure 3-2 Connecting High-Power Power Supply Module