Specifications

Ethernet Design Considerations
RADring
Installation & Operation Manual
7-2 Ethernet Physical Design 3/11/98 12:25
If problems are found, network design is refined by dividing stations into
smaller segments, using cable with lower attenuation and similar solutions.
After several iterations, a reliable, cost-efficient design is obtained.
A typical design procedure consists of the following steps:
1. Define location of nodes
2. Define location of future nodes
3. Select the topology
4. Define location of wiring closets
5. Select the media to be used
6. Complete a cabling table
7. Calculate the worst-case scenario
8. If required, decide upon placement of bridges
9. Verify network design
10. Calculate the cost per node
11. For large networks, select a new topology and repeat the procedure
12. Implement the design which best meets the objectives listed above.