Specifications

Chapter 4 Configuration Installation and Operation Manual
4-12 Displaying the Modem Status ASMi-31 Ver. 3.0
 LLB+BERT (local loopback in conjunction with BER testing is performed
by the local unit)
 RLB+BERT (remote loopback in conjunction with BER testing is
performed by the local unit)
 DTE->LLB (local loopback is being performed by the local DTE)
 DTE->RLB (remote loopback is being performed by the local DTE)
 REMOTE TEST (a test is performed by the remote unit (to find out
which specific test is run, scroll to LINE STATUS→REM→TEST).
 VERSION (software version).
• DTE parameters:
 DATARATE (data rate)
 INTERFACE (DTE interface type)
 MODE (transmission mode)
 FORMAT (async data format)
 CNT SIG-DCD (DCD signal status)
 CNT SIG-DSR (DSR signal status)
 To display the modem status:
1. Press the CURSOR button to move the cursor to the Menu Type field.
2. Press the SCROLL button until LINE STATUS or DTE STATUS is displayed.
3. Press the CURSOR button to move the cursor to the LOC/REM field.
4. Press the SCROLL button to select the local modem or the remote modem (if
the management link is not active, remote modem is not available).
5. Press the CURSOR button to move to the Menu Options field.
6. Press the SCROLL button to scroll through the menu options, to one of the
line/DTE parameters and is values (see
Figure 4-14 or Figure 4-15 ).