Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-31 Ver. 3.0 Displaying the Modem Status 4-11
 To match the two modems configuration:
1. When a CONFIG MISMATCH alarm is stored in the alarm buffer, press the
SCROLL button to display the CONFIG MATCHING ACCORDING TO message on
LCD (see
Figure 4-13 ).
2. Press the CURSOR button to reach the Parameters field.
Using the SCROLL button, select the unit according to which you wish to
configure both sides of the line (local or remote).
3. Press the ENTER button to configure the units (a WAIT ... message is
displayed on the LCD for a short while, while the units are being configured).
The unit returns to the ALARM BUFFER menu and the CONFIG MISMATCH
alarm is erased.
The local modem stores the parameters of the last time it was configured.
Some of these parameters are the parameters of the DTE interface of the
local modem and the remote modem. When the CONFIG MATCHING function
is employed, these parameters are set for both modems.
ALARM BUFFER LOC
CONFIG MISMATCH
Figure 4-12. CONFIG MISMATCH Alarm
LOC
CONFIG MATCHING
ACCORDING TO
REM
LOC
Figure 4-13. Matching Line and DTE Configuration Parameters
4.5 Displaying the Modem Status
ASMi-31 management software allows you to display the current configuration
status of the line and DTE interfaces of the modem.
• Line parameters:
 CLKTYPE (clock mode)
 ADAPT (rate adaptation mode)
 TEST (test which is currently performed)
 NONE (no tests are active)
 LLB (local loopback is being performed by the local unit)
 RLB (remote loopback is being performed by the local unit)