Specifications

Chapter 4 Configuration Installation and Operation Manual
4-4 Configuring the DTE Parameters ASMi-31 Ver. 3.0
4. Press the SCROLL button until ADAPT is displayed (see Figure 4-4 ).
5. Press the CURSOR button to move the cursor to the Parameters field.
6. Using the SCROLL button, select RAD PROP or V110 and press the ENTER
button to set your choice.
When configured to the V.110 rate adaptation, ASMi-31 operates in the internal
or receive clock.
CLKTYPE
ADAPT
LINE CONFIG
*RAD PROP
RAD PROP
ADAPT
V110
Figure 4-4. Selecting Rate Adaptation
4.3 Configuring the DTE Parameters
The DTE CONFIG menu allows you to select ASMi-31 transmission mode (sync or
async), data format for async mode, data rate, DCD and DSR signal transfer
mode, and enable or disable acceptance of local/remote loopback commands
from the DTE.
Configuring Transmission Mode
ASMi-31 supports synchronous and asynchronous transmission modes.
 To select transmission mode:
1. Press the CURSOR button to move the cursor to the Menu Type field.
2. Press the SCROLL button until DTE CONFIG is displayed.
3. Press the CURSOR button to move the cursor to the Menu Options field.
4. Press the SCROLL button until MODE is displayed (see
Figure 4-5 ).
5. Press the CURSOR button to move the cursor to the Parameters field.
6. Using the SCROLL button, select SYNC or ASYNC and press the ENTER button
to set your choice.
If the current data rate fits only one mode (sync or async), and you have selected
the other mode, the new configuration is not accepted and a message ILLEGAL
MODE is displayed. In such case you must first configure the data rate and the
mode will adapt to the rate and change automatically.
For complete list of ASMi-31 burst messages, refer to Chapter 5.
Note
Note