Specifications

Installation and Operation Manual Chapter 1 Introduction
ASM-61 Ver. 1.0 Technical Specifications 1-5
Line Attenuation
See Table 1-1
Power Spectral
Density
-58 dBm/Hz to -98 dBm/Hz, as per ETSI TS 101270-
1 requirements
Spectral Placement
Downstream: 0.9 MHz to 3.5 MHz
Upstream: 4 MHz to 7.9 MHz
Connector
RJ-45; pin 4 and pin 5
10/10Base-T
Interface
Network Topology
Ethernet extension
Port
One 10/100 Mbps LAN
Autonegotiation
Always enabled (for appropriate configuration mode)
Standard
IEEE 802.3, IEEE 802.3q
Mode
Half-duplex, full-duplex, backpressure support
Maximum Packet Size
1536 bytes
Backpressure
Always ON
Latency
2.5 msec for 1518-byte packet (end-to-end)
Connector
RJ-45
Diagnostics
Self-Test
Self-test at startup
Indicators
PWR (green)
Power
SYNC (green/red)
VDSL line synchronization
LAN (yellow)
Ethernet traffic is detected
ACT (yellow)
Ethernet traffic is detected
LINK (green)
Good link integrity
Physical
Height
44 mm (1.7 in 1U)
Width
237 mm (9.3 in)
Depth
170 mm (6.7 in)
Weight
0.58 kg (1.4 lb)
Power
Combined AC/DC
100 to 240 VAC (±10%), 50 to 60 Hz, 4.6W
-48 VDC (-36 to -72 VDC), 7W
Fuse
0.250A, slow-blow
Environment
Temperature
0–50°C (32–122°F)
Humidity
Up to 90%, non–condensing