Specifications

Chapter 5 ASM-10/8/R Card Version ASM-10/8 Installation and Operation Manual
5-6 Installing the ASM-10/8/R Card
5.4 Installing the ASM-10/8/R Card
Setting Internal Jumpers and Switches
The ASM-10/8/R internal jumpers and switches are similar in their functionality to
those of the standalone unit. For the details on the internal settings, refer to
Figure 2-1 and Table 2-1.
Installing ASM-10/8/R into the ASM-MN-214 Card Cage

To install the ASM-10/8/R card in the ASM-MN-214 card cage:
1. Install the ASM-MN-214 card cage in the 19-inch rack.
2. Insert the ASM-10/8/R card into one of the ASM-MN-214 slots.
3. Push the card into the cage until it is fully inserted into the edge connector
inside the rack.
4. Tighten the screws on front panel of the modem card.
Connecting the Interfaces
ASM-10/8/R uses the ASM-MN-214 rear panel terminal block ports for the line
connections. The 25-pin D-type female connector serves as a DTE port.
1. Remove the protection cover from the terminal block connectors.
2. Connect the terminal block to the ASM-MN-214 terminal block connector.
3. Connect the line to the terminal block as follows: connect transmit pair to the
terminals marked XMT, the receive pair to the terminals marked RCV, and the
fifth screw to ground (optional).
4. Connect the DTE cable to the DB-25 connector.
5. Connect power to the ASM-MN-214 card cage:
 To connect AC power, connect the power cable to the mains supply.
 To connect DC power, refer to DC Power Supply Connection Supplement
of the ASM-MN-214 Installation and Operation manual.
The ASM-MN-214 card cage has no power switch. Operation starts when the
power is applied to the rear panel POWER connector. When applying power,
first connect the plug of the power cord to the ASM-MN-214 POWER
connector and then to the mains power source (outlet).
Warning