Specifications

ASM-10/8 Installation and Operation Manual Quick Start Guide
Installing ASM-10/8 3
Item Jumper Description Values Default Setting
12 CTS-DLY Selects delay between RTS and CTS
0 msec
8 msec
64 msec
8 msec
13 Data Rate Selects the data rate
0 – 19.2
1 – 14.4
2 – 9.6
3 – 7.2
4 – 4.8
5 – 3.6
6 – 2.4
7 – 1.2
9.6
14 XMT TIMING Selects the transmit timing signal clock
source
INT CK – Internal clock
EXT CK – External clock
RCV CK – Receive clock
ASYNC – Async mode
INT CK
15 DIP Switch The DIP switch consists of four sections. The S1 section is reserved for future use.
S2 Selects the amount of stop bit
shortening to be used in async mode.
ON – 25%
OFF – 12.5%
OFF
S3, S4 Selects character length in async mode
S3 S4 No of bits
OFF OFF 8 BIT
OFF ON 9 BIT
ON OFF 10 BIT 10 BIT
ON ON 11 BIT
Connecting the Cables
Connecting the Line

To connect the line:
• Connect the line cable to the terminal block connector on the ASM-10/8 rear
panel.
Connecting the DTE

To connect the DTE:
• Connect the DTE cable to the DB-25 female rear panel connector.