Specifications

AMC-101 Package Contents 2-1
Chapter 2
Installation and Setup
This chapter describes installation and setup procedures for the AMC-101 unit.
AMC-101 is delivered completely assembled. It is designed for tabletop or 19-inch
rack installation. For instructions on installation of a single unit or two units in a
19-inch rack, refer to the rack mounting kit for 19-inch racks guide that comes
with the RM kit.
After installing the unit, refer to Chapter 3 to assure normal operation.
In case a problem encountered, refer to Chapter 4 for test and diagnostic instructions.
Internal settings, adjustment, maintenance, and repairs may be performed
only by a skilled technician who is aware of the hazards involved.
Always observe standard safety precautions during installation, operation, and
maintenance of this product.
2.1 Site Requirements and Prerequisites
An AC-powered AMC-101 should be installed within 1.5m (5 ft) of an easily
accessible grounded AC outlet. The outlet should furnish 100–230 VAC current.
A DC-powered AMC-101 unit requires -48 VDC power source, which must be
adequately isolated from the mains supply. In order to prevent a fire hazard, a
suitable fuse should be installed in the DC line.
Allow at least 90 cm (36 in) of frontal clearance for operating and maintenance
accessibility. Allow at least 10 cm (4 in) clearance at the rear of the unit for signal
lines and interface cables.
The ambient operating temperature of AMC-101 is 0 to 50°C (32 to 122°F) at
relative humidity of 90%, non-condensing.
2.2 Package Contents
The AMC-101 package includes the following items:
• One AMC-101 unit
• Interface card(s)
• Technical documentation CD
• AC power cord or DC power supply connector kit
• RM-101 rack mount kit (if ordered).
Warning