Specifications

Quick Start Guide Installation and Operation Manual
2 Operating AMC-101 AMC-101
Installing Interface Modules
The AMC-101 interface modules are hot-swappable, that means they can be
replaced when the unit is ON.

To install an interface module:
1. Slide the module into appropriate slot.
2. Fasten the two front panel screws to secure the module to the AMC-101
frame.
Connecting the Cables

To connect the fiber optic cables:
1. Remove the protective caps from the connectors and store them in a safe
place for later use.
2. Connect the transmit fiber to the connector marked TX and the receive fiber to
the connector marked RX.
3. At the remote unit connect the transmit fiber to RX and the receive fiber to TX.

To connect AC power to AMC-101:
1. Connect the power cable to the power connector on the AMC-101 rear panel.
2. Connect the power cable to the mains outlet.
The unit will be turned on automatically upon connection to the mains.

To connect DC power to AMC-101:
• Refer to DC power supply connection supplement.
2. Operating AMC-101
AMC-101 requires no operator attention once installed, with the exception of
occasional monitoring of front panel indicators. Refer to table below for the correct
status of the AMC-101 indicators after the local and remote units are synchronized
and data is being transferred.
Indicator Status
PWR ON
FLT (AMC-101) OFF
WRAP OFF
SIG ON