Owner`s manual

Installation
2-2
External wiring which connects an I/O module to instruments/devices may
not exceed 42.67m (140 feet).
If the ACE3600 is subject to high levels of shock or vibration, you must
take suitable measures to reduce the acceleration or amplitude. We
recommend that you install the ACE3600 on vibration-damping materials
(for example, rubber-metal anti-vibration mountings).
METAL PARTS OF THE POWER SUPPLY MAY BE VERY HOT.
After removing the power supply module, allow the metal parts to cool
down before servicing the unit.
Mounting the ACE3600 Frame on a Wall
Before drilling holes for mounting the frame, make sure there are no
electrical wires installed inside the wall at the holes’ location.
Four holes are provided, one in each corner of the RTU frame, for wall mounting the RTU.
Figure 2-1, Figure 2-2, and Figure 2-3 show the dimensions of the various frames/metal chassis
and the distances between the holes. For convenient installation of the ACE3600 RTU on a
wall, allow an additional 6 cm (2.4") (in W, H) and 7 cm (2.75") (in D) around the plate.
295
330
410
443
Small Metal Chassis Large Metal Chassis
Figure 2-1. Small/Large Metal Chassis Installation Dimensions and Screw Holes for
Installation