Owner`s manual

Radio Types and Installation Kits
11-28
Figure 11-25 GP/HT/PRO Radio Installed on ACE3600 Chassis
RTU Port Configuration for the GP320/GP328/HT750/PRO5150 Radio
To enable MDLC communication using GP320/GP328/HT750/PRO5150 radios, use the
ACE3600 STS site configuration utility to configure the ACE3600 RTU plug-in port
connected to the radio.
The following figures show the port configuration and advanced parameter configuration.
Although these show Port PI1, the same values can be applied to port PI2 as well, where
relevant.
Port Type
Procedure 11-15 How to Configure the ACE3600 Port for the GP/HT/PRO Radio
1. In the ACE3600 STS click on the desired site, and open the site view.
2. In the Port Tab, click on the plug-in port through which the RTU will communicate with
the radio.
3. Confirm that the port parameters and data speed are as shown in the screen below.
Radio
Antenna
Cable
(
FKN8434A)
Power
Cable
(
FKN8433A
)
Signal
Cable
(
FKN8431)
Power Supply CPU Antenna Cable
N-Type Connector
Radio
Bracket
(
FHN6899A
)