Owner`s manual

Radio Types and Installation Kits
11-19
Radio Disassembly
If the CDM750 radio is to be programmed outside of the ACE3600 housing, disassemble the
radio as follows:
Procedure 11-12 How to Disassemble the CDM750 Radio from the ACE3600 Metal Chassis
1. Disconnect the antenna cable (FKN8437A) to the radio Antenna connector.
2. Remove the radio/bracket unit from the RTU chassis by unscrewing the four built-in
screws.
3. Disconnect the DC power cable (FKN8436A) from the radio Power connector.
4. Disconnect the radio adapter (FLN3639A) 16-pin connector from the radio Accessory
connector.
5. Detach the metal bracket (FHN6898A) by unscrewing the two radio screws
(#0387839V89), one on each side. (See Figure 11-9.)
CPS Programming Settings
The following programming instructions must be performed before connecting a CDM750
radio to the ACE3600 family Remote Terminal Units (RTU). These instructions define
miscellaneous settings and the function of each pin in the radio’s general purpose I/O
connector.
Procedure 11-13 How to Program the CDM750 Radio
1. Before programming the radio, read the codeplug file from the radio and save it to your
PC using the File >Read Device command in the CPS.
2. Open the codeplug file in the CPS. Click on the codeplug in the tree view to view and
select the items below or select them from the Feature menu.
3. Under Radio Configuration, change the settings on the Basic, Tx Power, Accessory
Configuration, and Accessory Pins tabs, as shown in the screens below.
4. Under Controls and Menus->Conventional Buttons, change the settings to the Mobile
Key Buttons and Programmable Buttons tabs, as shown in the screens below.
5. Under Conventional Personality 1, change the settings to the Basic, Options and
Advanced tabs, as shown in the screens below.
6. Under Personality Assignment to Zone 1, make sure that the desired channel(s) appear on
the list on the Channels tab. If not all the assigned channels are required, remove them
from the assignment list.
7. From the File Menu, select Save to save changes to the radio.
8. From the File Menu, select Write Device to download the configuration to the radio.