Owner`s manual

Radio Types and Installation Kits
11-13
a. Click on Control Head.
b. Make sure that the control head is W4.
c. Click on Radio VIP.
1) Set VIP In for VIP 1, VIP 2, and VIP 3 to Blank.
2) Set VIP Out for VIP 1 to MOSCAD CG.
3) Set VIP Out for VIP 2 to MOSCAD TXE/CM.
4) Set VIP Out for VIP 3 to NULL.
4. Double-click on Conventional ->Conventional Personality -> Conventional Personality 1.
a. In the Rx Options tab, set Unmute/Mute Type to UnMute, Or Mute.
b. Set Rx Voice/Signal Type to Non-Astro.
c. Enable (check) Rx Emphasis and Busy LED.
d. In the Tx Options tab, make sure that the Time Out Timer is set to 3 (for 60 sec).
e. Set Tx Voice/Signal Type to Non-Astro.
f. Set Transmit Power Level to High.
5. Double-click on Trunking ->Trunking System ->Trunking System 1.
a. In the General tab, if the proper system key was loaded, the System Key field
should already be enabled.
b. Set the Type to II.
c. Set the Type II System ID, and Connect Tone to values obtained from the radio
system administrator for the site.
d. Under Coverage Type, set the type to Disabled.
e. In the Type II tab, set the Individual ID to the value obtained from the radio
system administrator for the site.
f. Set the Affiliation type to Automatic.
g. In the Channel Assignment tab, enter the Rx and Tx channel ranges. Consult
your radio system administrator for the list of values.
h. In the OBT Control Channels tab, set the RX Frequency and TX Frequency of
each control channel with which the data subscriber should be able to affiliate.
Consult your radio system administrator for the list of control channels.
6. Double-click on Trunking ->Trunking Personality ->Trunking Personality 1.
a. In the General tab, set the Protocol Type to II and set the System ID to the value
obtained from the radio system administrator for the site. Make sure that the