Owner`s manual

Radio Types and Installation Kits
11-12
2. In the Port Tab, click on the plug-in port through which the RTU will communicate with
the XTL5000 radio.
3. Set the port parameters as shown in the screen below. The Trunk system parameter
should reflect the type of trunking system (e.g. SmartNet, SmartZone.)
4. Save the changes.
Figure 11-7 RTU Site Configuration for MDLC over Analog Trunked System – Port Type
Parameters
Programming the XTL5000 Analog Trunked Radio using CPS
The XTL5000 radio is programmed for ACE3600 in the factory and is ready for analog
trunked communication. For user programming of site-specific parameters, the radio should be
brought to the Motorola Service Center.
Radio Connections
Follow the Radio Connections instructions described under Radio Programming using CPS for
the Astro IV&D Digital above.
Radio Disassembly
Follow the Radio Disassembly instructions described under Radio Programming using CPS for
the Astro IV&D Digital above.
CPS Programming Settings
Before programming the radio, read the codeplug file from the radio and save it to your PC
using the File >Read Device command in the CPS (DSP version R06.00.00 for radio firmware
R06.01.00.) Open the codeplug file in the CPS and set the parameters as follows.
Procedure 11-8 How to Program the XTL5000 Analog Radio
1. In the CPS, click on the codeplug in the tree view to view and select the items below or
select them from the Feature menu.
2. Under Radio Configuration, double-click on Radio Wide.
a. In the Transmit Power Levels tab, reduce the radio power level to low: Change
TX Power Level Low for Freq. Range A from 28.0 to 10.
1) Change TX Power Level High for Freq. Range A from 53.5 to 15.
b. In the Advanced tab, make sure that "MOSCAD Data Enable" is enabled.
c. In the Time Out Timer tab, make sure the Time # is set to 3 (for 60 sec).
3. Double-click on Controls.