User`s manual

5620 Model Descriptor for LA-110 User’s Manual Chapter 4 Port Configuration and Monitoring
SHDSL Port Configuration 4-45
Table 4-23. SHDSL Port – ATM Layer Parameters
Parameter Remarks
Port The selected port
SHDSL
Read-only
Type The protocol application which runs above the physical port.
ATM
Read-only
Max Supported
VCCs
The maximum number of VCCs supported at this ATM interface.
18
Read-only
No. of
Configured
VCCs
The number of VCCs currently in use at this ATM interface.
Read-only
Max Active VPI
Bits
The maximum number of active VPI bits configured for use at the ATM interface. At the
ATM UNI, the maximum number of active VPI bits configured for use ranges from 0 to 8
only.
5
Read-only
Max Active VCI
Bits
The maximum number of active VCI bits configured for use at this ATM interface.
8
Read-only
Free Bandwidth
(cell/sec)
The free rate in cells/sec.
Output rate – Allocated BW
Read-only
Idle Cell CLP Determines the CLP bit value for transmission in empty time slots.
CLP0, CLP1
Scrambling Adds scrambling to the communications with the network.
Enable, Disable
Shaping Mode The shaping mode
SW
HW, NCITS=1
HW, NCITS=2
Jitter Buffer
(msec)
The field is set in ms and sets the Jitter Buffer size. The Jitter Buffer adapts the size of the
LA140 traffic to the CDV (cell delay variation) of the ATM network.
1…30