User`s manual

5620 Model Descriptor for LA-110 User’s Manual Chapter 4 Port Configuration and Monitoring
SHDSL Port Configuration 4-37
Physical Parameters

To configure SHDSL port physical layer parameters:
1. In the LA-110 Node Draw, select the SHDSL port, right-click and select
Configure > Physical Layer > Parameters.
Figure 4-29. SHDSL Port – Physical Layer Parameters
2. Fill in the fields, as described in Table 4-20.
3. Click <Save> to save the changes.
Changing the uplink physical layer parameters may cause a temporary
disconnection of management for a few seconds, until the SHDSL port is
synchronized with the new parameters.
Note