User`s manual

5620 Model Descriptor for LA-110 User’s Manual Chapter 4 Port Configuration and Monitoring
LAN Port Configuration 4-29
5. Click <Save> to save the changes.
To add/change Bridge port members, refer to the following section, "Selecting
VLAN for Membership".
Table 4-14. Bridge Port (VLAN Aware) VLAN Table Parameters
Parameter Remarks
VLAN ID The VLAN-ID or other identifier referring to this VLAN.
1…4094
VLAN Name An administratively assigned string, which may be used to identify the VLAN.
String of up to eight characters
Bridge Port Bridge Port selection is possible only for a new entry.
ATM: ports 1…16
Ethernet: port 9
Selecting VLAN for Membership
This menu option is disabled if no VLAN is defined.

To configure VLAN for membership parameters:
1. In the LA-110 Navigator, select the Bridge port (VLAN Aware), right-click and
select Configure > Select VLAN for Members.
Figure 4-22. Bridge Port (VLAN Aware) Select VLAN for Membership
2. Select the VLAN ID for which you would like to configure members, as described
in Table 4-15.
3. Click <Save> to save the changes.
The NMS checks if the VLAN ID exists. If it does, the VLAN Members for
the Selected VLAN ID form opens. If the VLAN ID does not exist, then an
error message appears.
Now it is possible to add or remove members from this VLAN.
Note