User`s manual
5620 Model Descriptor for LA-110 User’s Manual Chapter 4 Port Configuration and Monitoring
LAN Port Configuration 4-21
Port Application
The LA-110 has two possible port applications: Bridge and IP Router. Although,
the two are supported by the device, only Bridge is supported by the current MD.
The device default setting is Bridge. However, if the device should happen to go
up as Router, you can set it back to Bridge in the Port Application dialog.
To configure LAN port application:
1. In the LA-110 Node Draw, select the LAN port, right-click and select
Configure > Port Application.
Figure 4-15. LAN Port Application
2. Fill in the fields, as described in Table 4-10.
3. Click <Save> to save the changes.
Table 4-10. LAN Port Application Parameters
Parameter Remarks
Port The selected port
LAN
Read-only
Type The protocol application which runs above the physical port.
Ethernet Csmacd
Read-only
Port Application
Bridged Ethernet