User`s manual

5620 Model Descriptor for LA-110 User’s Manual Chapter 3 System Configuration and Monitoring
Viewing and Modifying Traffic Descriptor Settings 3-9
Table 3-4. Traffic Descriptor Table Parameters (Cont.)
Parameter Valid Ranges/Remarks
Type The ATM traffic descriptor type. The number of parameters and their meaning depends
on the TD type.
UBR, UBR+, CBR, VBR
Read-only
PCR[0+1]
(cell/sec)
Peak Cell Rate. The maximum rate of cells accepted from the user
79…5452
SCR[0+1]
(cell/sec)
Sustainable Cell Rate. The long-term average cell rate provided by the user.
Relevant only to VBR mode
79…5452
MBS[0+1] (cells) Maximum Burst Size. The maximum number of cells allowed in a single burst. Longer
bursts may be discarded.
Relevant only to VBR mode
1…10 (default)
…999
MDCR (cell/sec) Minimum Desired Cell Rate.
Relevant only to UBR+ mode
1…200 (default)
…5452
3. To add a row to the Traffic Descriptor Table, select Table > Add Row.
The Create a Row dialog box opens, in which you can configure the Traffic
Descriptor Index.
Figure 3-7. Create a Row Dialog Box
4. Click <Add Row>.
A new row is added to the table with the new values. You can add up to a
maximum of 200 rows to the table.