User`s manual

Chapter 3 System Configuration and Monitoring 5620 Model Descriptor for LA-110 User’s Manual
3-6 Viewing and Modifying Host Interface Parameters
Table 3-2. System Parameters
Parameter Valid Ranges/Remarks
Clock Source Indicates which clock is used
Internal, Derived from Main, NTR, Adaptive, Derived from (E1) User
Read-only.
Enable ILMI VCC (If ILMI VCC is disabled, the following fields will be disabled.)
VPI The ILMI VPI
0..31
VCI The ILMI VCI
0..255
Status The ILMI status
Active, Not Active
Note the following:
ILMI VPI and VCI cannot both be set to zero
Changing the values of ILMI parameters may disconnect the NMS from the Agent
ILMI VCC should be different from the management channel.
3.4 Viewing and Modifying Host Interface Parameters
LA-110 MD allows you to determine the IP address of the host, the management
channel, and the traffic parameters for this channel.
To view/modify host interface parameters:
1. In the LA-110 Node Draw, select the system (as described in Selecting the
System), and from the menu bar, select
Object > Configure > Host Interface Parameters.