User`s manual

5620 Model Descriptor for LA-110 User’s Manual Chapter 6 Path Management
Configuring Data FR and AAL1 Stream Paths 6-23
6. Click <Delete>.
A confirmation message appears.
7. Click <OK> to confirm the deletion.
The selected link is deleted.
6.7 Configuring Data FR and AAL1 Stream Paths
Configuring Data FR and Data AAL1 Stream paths is a two-stage process:
1. Configure a non-cross-connected path between SHDSL ports.
2. Configure a Data FR or AAL1 Stream 5620 DM connection in the LA-110
node.
The same settings for the ATM VPI and VCI values designated in stage 1 are to be
used in stage 2.
Configuring Data FR Paths
Stage 1: Setting up the Data Path with Two Non-Cross-Connected
Path Endpoints

To configure the Data FR path:
1. In the Entire Network Map, select the same LA-110 node used in the previous
(link configuration) procedure, right-click and select
Create > ATM and TDM > Paths > ATM > VCC.
The New ATM VCC Path form opens (see Figure 6-7) where you can
proceed to designate the Source and Destination points.
2. Double-click the node to open its Shelf View.
3. Select the SHDSL slot to open the SHDSL Port zoom view.
4. Click the SHDSL Port to highlight it.
5. In the New ATM VCC Path form, click the <Source> button to designate the
path source endpoint.
6. In the Entire Network map, double-click on the second
SHDSL module to open its Shelf view. (It can be another
LA-110 or SHDSL port in DSLAM).
7. Double-click the SHDSL module to open the ESE's SHDSL
Port zoom.
Note