User`s manual

Chapter 6 Path Management 5620 Model Descriptor for LA-110 User’s Manual
6-22 Deleting Paths and Links

To delete paths:
1. In the List Paths form (as shown in Figure 6-23), click the <Disconnect All>
button to disconnect all the paths listed. (Alternatively, you can disconnect the
paths one by one.)
A confirmation message appears.
2. Click <OK> to confirm.
3. In the Paths List (see Figure 6-23), double click the path you want to delete.
The Configure ATM VC Path form (see Figure 6-13) for the selected path
opens.
4. In the Configure ATM VCC Path form, click the <Delete> button.
The New ATM VCC Path form opens (see Figure 6-7), showing an empty
form and a confirmation message that the path request is deleted.
5. To delete links, do any one of the following:
 In List Links form, click the <Make List> button and from the Links List,
select the relevant link row, and double-click to open the Configure Full
Link form.
OR
 In the Entire Network map, double-click the link to open the Link Group
form where you can click in the middle area to open the Configure Full
Link form.
Figure 6-25. Link Group