User`s manual

5620 Model Descriptor for LA-110 User’s Manual Chapter 5 Cross Connection
Configuring Cross Connections 5-11
Table 5-6. Edit VCL Connection Parameters
Parameter Valid Ranges/Remarks
VPI The VPI value of the VCL.
0…31
Read-only
VCI The VCI value of the VCL.
0…255
Read-only
Traffic Descriptor
1…200
Continuity Check The VCC admin status.
Off Two Way (down), On Two Way (up), On-source, On-sink
Operational
Status
Up, Down
The following fields are available only for Bridge - VLAN Aware.
Connected To
ATM Bridge Port
1…existing ATM Bridge port number, Not Connected
VLAN Priority
VLAN Priority
Enable
Select: enables you to select any priority
All: all priorities are selected. (Selectable if selected Bridge Port is not connected to
any VCL or if selected Bridge Port is connected only to the VCL that is being edited
now)
None: this value is not selectable and will be displayed when “Not Connected” selected
in “ATM Bridge Port” field
Priorities 0…7
Free, On, N/A, Used.
If this priority is assigned to the selected VCL The value is “On”.
If this priority is assigned to another VCL other then the selected VCL Then the value is
“Used – VPI/VCI “ where VPI/VCI are of the assigned VCL.
If this priority is not assigned to any of the existing VCLs The value is “Free”.
Only “Free” and “On” are selectable values
The value “N/A” is not selectable and represents a new connection where the VLAN
Priority field value is “All”.
Loopback Testing

To configure LAN VC connection loopback testing:
1. In the Navigator, select the LAN VC Connections container, right-click and
select Configure > Loopback Test.