User`s manual
5620 Model Descriptor for LA-110 User’s Manual Chapter 5 Cross Connection
Configuring Cross Connections 5-9
Table 5-5. LAN VC Connections Info Parameters (Cont.)
Parameter Valid Ranges/Remarks
Traffic Descriptor
1…200
Read-only
Continuity Check The VCC admin status.
Off Two Way (down), On Two Way (up), On-source, On-sink
Read-only
Last Change This field indicates the time of the last change on the port.
Read-only
The following fields are available only for Bridge VLAN Aware.
Connected To
Bridge Port #, Not Connected
Priorities
0…7
VCL Connection
To edit a LAN VCL cross connection:
1. In the Navigator, select the LAN Connection, right-click and select
Configure > Edit LAN VCL Connection.
The Edit LAN VCL Connection form opens in which you can connect the
bridge port to the VCL and assign VLAN Priority to the connection. (This is
only applicable to VLAN Aware mode.)
An ATM Bridge Port can be connected to up to three
VCLs according to
the following conditions:
Each connection includes a VLAN Priority, which can be one or more
values from a specified VLAN Priority Range (0…7).
Two connections of the same ATM Bridge Port CANNOT share the
same VLAN Priority.