User`s manual
5620 Model Descriptor for LA-110 User’s Manual Chapter 5 Cross Connection
Adding Cross Connections 5-7
3. Fill in the fields, as described in Table 5-4.
4. Click <Save> to save the changes.
Table 5-4. AAL1 Stream VC Connections Parameters
Parameter Valid Ranges/Remarks
ATM
VPI The VPI value of the ATM end point.
0…31
VCI The VCI value of the ATM end point.
0…255
AAL1 Stream
Rx Bytes per
Cell
10…47 (default)
Tx Bytes per
Cell
10…47 (default)
Connection
Type
Unstructured, Structured
The values depend on the port data Rate (64..2048 Kbps) and on the RTS DCD (on, off, or
not applicable)
Only “Structured (Signals Transported)” is visible, when the RTS DCD is 1 (ignore signal) or
2 (obey signal). For other values of RTS DCD, display values depends on Rate = 64 K
(r64KBps) possible values are:
• Structured with Pointer,
• Structured without Pointer
• Structured (Signals Transported)
For Rate <> 64 Kbps, possible values are:
• Unstructured,
• Structured,
• Structured (Signals Transport
Pointer Parity
Not Applicable, Off, On
List of possible values depend on Connection Type, as follows:
• Unstructured: NA,
• Structured: ON, OFF
• Structure with Pointer: ON, OFF
• Structured without Pointer: NA
• Structured (Signals Transported): NA
Continuity
Check
The VCC admin status.
Off Two Way (down), On Two Way (up), On-source, On-sink
Read-only