User`s manual

Chapter 5 Cross Connection 5620 Model Descriptor for LA-110 User’s Manual
5-2 Adding Cross Connections
To add a LAN VCL cross connection:
1. In the Navigator, double-click the Connections container to display the LAN
VC Connection.
2. Select the LAN VC Connections container, right-click and select
Add Component > Cross Connection > Add LAN VCL.
Figure 5-1. Add LAN VCL Connection
3. Fill in the fields, as described in Table 5-1.
4. Click <Save> to save the changes.
Table 5-1. Add LAN VCL Connection Parameters
Parameter Valid Ranges
VPI The VPI value of the VCL.
0…31
VCI The VCI value of the VCL.
0..255
Traffic
Descriptor
Identifies the row in the Traffic Descriptor (TD) Table which applies to the transmit
direction of the VCL.
1…200 (values available as defined in TD table)
Continuity
Check
The VCC admin status.
Off Two Way (down), On Two Way (up), On-source, On-sink
Read-only
CES VC Connection
To add a CES VC cross connection:
1. Verify bundles are associated with timeslots (see the section, "Bundles
Configuration" (for CES E1 ports) in the "Port Configuration and Monitoring"
chapter.)