Operating Guide

H O M E S T O R A G E P R O D U C T S

WWW.RACORSTORAGESOLUTIONS.COM

WARNING

Please read installation instructions carefully prior to installing. Before

using the product thoroughly test the fully-weighted product (with equip-

ment in place) to ensure the product has been installed properly. Do not

allow children to play on product. ITW Brands is not responsible for any

damage resulting from improper installation, overloading or product

failure.

TRIPLE SKI HANGER | PS-3R

INSTRUCTIONS

Phillips driver

1/8” Drill bit

Drill

TOOLS REQUIRED

PARTS LIST

x1 Ski rack

x2 2’’ (5 cm) wood screws

This rack has been designed to be

installed into studs 16” on center.

Determine the height by taking your

longest pair of skis, placing them into

rack while holding rack against wall.

Make a mark at this level through

screw holes.

PAGE 1
HOME STORAGE PRODUCTS TRIPLE SKI HANGER | PS-3R INSTRUCTIONS WWW.RACORSTORAGESOLUTIONS.COM TOOLS REQUIRED PARTS LIST Phillips driver x1 1/8” Drill bit Ski rack Drill x2 WARNING 2’’ (5 cm) wood screws Please read installation instructions carefully prior to installing. Before using the product thoroughly test the fully-weighted product (with equipment in place) to ensure the product has been installed properly. Do not allow children to play on product.
PAGE 2
MARK 2 Both wood screws must be fastened into a vertical stud inside the wall. A USING THE SKI RACK Mark holes through rack mounting plate and drill 1/8” pilot holes. Install screws into vertical stud. Tighten screws firmly. Place skis so the bottoms of both are facing each other. Interlock the brakes on the skis so the two skis are joined together with one brake over the other one. Place the joined skis between the double hook and the ski tips will wedge into position holding the skis.