Specifications

• PoE – via Ethernet connector RJ-45 using PoE standard IEEE802.3af. Voltage 38-57 V. Common

version of supplying:

plus to pins 4+5

minus to pins 7+8

the polarity can be inverted also

For other options with PoE adapter see the standard IEEE802.3af.

To connect the power supply via Ethernet connector, can be used Passive PoE injektor.

Important

Only ONE of the above power supply options can be used !

Examples and details in Chapter 6, Radio modem installation.

3.5. Indication LEDs

PWR

ETH

232

STATUS

ANT.

RS232

ETH

RST

Fig. 3.4: Appearance of radio modem

Key to LEDs

PWR Yellow – AUX (power via RS232)•

• Green – PoE (power via Ethernet)

TX Red - transmitting•

RX Green – RF sync•

• Yellow – there is a signal stronger than -80 dBm on RF channel (or transmitting proceeds)

ETH Yellow – connected with 100 Mb/s speed•

• Yellow flashing – data transfer with speed of 100 Mb/s

• Green - connected with 10 Mb/s speed

Connectors