Installation Guide

Paintable:
Want a different color? The finish on this pot rack can be spray painted any color. We recommend Rustoleum
“Hammered” colors for their metal-like finishes, however any quality spray-can paint may be used. See a paint retailer for
guidance.
Tools Needed:
Provided: Installation wall anchors, bolts and hex wrench.
You will need: level, tape measure, pencil, drill and 1/8” drill bit, hammer and nail
STEP 1: Location
Decide where you want to place your utensil bar. Consider the height of the wall where the bar will hang, keeping in mind
how far below the bar your pot and utensils will hang.
On the wall (use a level to ensure that the bar is horizontal) mark the two points where the bar will attach. Then tap a
small nail through each mark to be certain a stud is not in the way. (NOTE: because your utensil bar includes toggle an-
chors that can hold 100s of pounds, you DO NOT need to locate and bolt to studs.)
STEP 2: INSTALL DRYWALL ANCHORS
RACK IT UP!’s drywall togglers eliminate the need to bolt your pot rack to a stud. The steel anchors are very strong and
when installed in drywall each drywall anchor holds about 50 lbs. Two anchors hold about 100 lbs., many times the weight
you will likely hang from your pot rack.
See Back of this Booklet for Toggle Instructions.
INSTALL IN WOOD
If you need to install one or both sides of your rack in wood, use as the two wall screws (30A) included. See back page of
booklet under Step 1.
CLEANING
Your bar has a durable powder coat finish designed to provide years of protection. Cleaning is done easily using soap and
a damp cloth. Dry thoroughly after cleaning.
______________________________________
ACCESSORIES
RACK IT UP
24 Colwell Street, Port Hadlock WA 98339
TOLL FREE [phone]
8 Pot Hooks
There’s always a need for extra
hooks. Set of eight hooks
(4 straight, 4 angle). Steel
with powder coat finish for
extra durability.