Installation Guide

Toggler ® Independent Lab Results
(Anchor load before failure per attachment point)
TENSILE (ceiling) SHEAR (wall)
½” drywall 275 lbs. ½” drywall 292 lbs.
5/8” drywall 576 lbs. 5/8” drywall 406 lbs.
Industry Standards recommend 1/4 of the ultimate test load
Installation of Drywall Anchors
Corner Shelf Rack
TOGGLER® brand SNAPTOGGLE® Toggle Bolt Installation Instructions. DO NOT attempt to
test the toggle as you will be unable to use them again. Need additional toggles? You may
purchase them at Lowes or find a local store on toggler.com.
IMPORTANT! If your house is older (maybe a Victorian?) with lath board plaster ceilings and walls, DO NOT use the new
drywall anchor system. Old lath board plaster walls are not strong enough to hold drywall anchors. In this case, you must
attach the wall rack to wood studs with wood lag screws (not included with your rack).
INSTALL TOGGLER ANCHOR
1) Using an electric drill, drill a ½” hole at each of the outside holes on
the straight sides of your rack. Hold metal channel flat alongside plas-
tic straps and slide channel through each hole. Minimum clearance
behind wall should be 1 ⅞”.
NOTE: If a wood stud happens to be located at one of those points,
Use a 3/16” x 1 ½” wood screw (provided) and screw it into the
stud. (Pre-drill a 1/8” hole in the stud so the screws are easier to
screw into the hole).
2) Firmly push plastic cap up along guide straps with other hand.
Press cap inside the hole, so flange is flush with drywall surface.
3) Bend straps at wall by pushing side to side, snapping off straps
level with flange of cap.
4) Repeat for the other hole on the opposite straight side of the rack.
5) Install the red sleeve anchors. Drill 5/16” holes at each of the
inside holes on the straight sides of your rack. With your hammer,
gently tap a red wall screw sleeve (30B) into each hole until it is flush
with the drywall surface.
6) Now position the rack on the wall ~ lining up hole(s) at the outside
and inside of the straight sides. Screw button head bolts (19C)
through rack side and into the outside toggle anchors. Screw wall
screws (30A) into the red sleeve anchors. Tighten bolts snugly.
That’s It! Now add the grid and you are ready to hang your
pots & utensils!