Installation Guide

TIP! FIRST, REMOVE PAINT FROM BOLT HOLES. Because the powder coat finish applied at the

factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be difficult. Therefore, before

connecting parts, we recommend that you check to see that bolts slip easily through all holes. If they do not, carefully clear

paint from holes in side bars, ends and arms using a small knife.

SECOND, be certain that barrel nuts and bolts screw together easily BEFORE beginning assembly. Residue from the black

finish may cause some bolts to stick a bit, therefore use the two hex wrenches enclosed (one for each end of the barrel)

and screw them together to clear away extra paint.

How To Assemble Your Pot Rack

Item No. Part Number

26A 5/32 hex key 1

8G Corner rack grid 1

30A Wall screw 4

46 Corner rack body 1

27A 1/4” toggle 2

Installation hardware

30B Wall sleeve 2

19C Button head screw 1/4” X 20 x 2” 2

38A Round head rivet 2

25A Pot hook straight 4

38B Flat head rivet 4

25B Pot hook angled 4

39 Push nut—rivet 6