Instructions / Assembly

TIP! SAVE TIME AND HASSLE. PLEASE READ ENTIRE INSTRUCTIONS BEFORE BEGINNING ASSEMBLY.
PAINTABLE - Want a different color? The finish on this pot rack can be spray painted any color. We
recommend Rustoleum “Hammered” colors for their metal-like finishes, however any quality spray-can paint may be
used. See a paint retailer for guidance.
TOOLS NEEDED - Hex wrench, fastener hardware (nuts, bolts) are provided.
STEP 1: LAYOUT PARTS
On a table lay out all parts as shown in the exploded view above.
STEP 2: CONNECT MAIN BODY PARTS
Temporarily connect two rectangle ends (2) by inserting a barrel nut (28B) and barrel bolt (28A) through the top hole on
each side. This will cause body of pot rack to stand on edge.
TIP! It is easiest to attach the pot rack parts when you insert the barrel nut from the INSIDE of the pot rack body, then
turn the barrel bolt(28A) into the nut from the OUTSIDE.
How To Assemble Your Pot Rack
TIP! FIRST, REMOVE PAINT FROM BOLT HOLES. Because the powder coat finish applied at the
factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be difficult.
Therefore, before connecting parts, we recommend that you check to see that bolts slip easily through all
holes. If they do not, carefully clear paint from holes in side bars, ends and arms using a small knife.
SECOND, be certain that barrel nuts and bolts screw together easily BEFORE beginning assembly. Resi-
due from the black finish may cause some bolts to stick a bit, therefore use the two hex wrenches enclosed
(one for each end of the barrel) and screw them together to clear away extra paint.
MISSING A PART?
Please call our TOLL FREE
SERVICE CENTER
1 [phone]
Item No. Description Qty. Item No Description Qty.
1 Angle arm 2 Installation hardware
2 Rectangle end 2 15 S-Hook 1
5 Hanging bracket 1 19A 1/4” bolt hook - 4” 1
7C Grid bracket 2 20 Wood screw hook - 4” 1
8C Grid 2 25A Pot hook straight 4
28A Barrel bolt 5 25B Pot hook angled 4
28B Barrel Nut 5 26A hex wrench 2
27A Toggle 1