Installation Guide

TIP! SAVE TIME AND HASSLE. PLEASE READ ENTIRE INSTRUCTIONS BEFORE BEGINNING ASSEMBLY.
ALL TOOLS NEEDED FOR
ASSEMBLY ARE PROVIDED-
Hex wrenches and
Fastener hardware (nuts, bolts)
STEP 1: LAYOUT PARTS
On a table lay out all parts as shown in the exploded view above.
STEP 2: CONNECT MAIN BODY PARTS
Temporarily connect two oval ends (4A) and two side bars (3A) by inserting a barrel nut and bolt (28A, 28B) through the
top hole at each of four corners. This will cause body of pot rack to stand on edge. Be certain side bars (3A) are on the
INSIDE when connected.
TIP! It is easiest to attach the pot rack parts when you insert the barrel nut (28B) from the INSIDE of the pot rack body,
then screw the barrel bolt (28A) into barrel nut (28B) from the OUTSIDE.
How to Assemble Your Pot Rack
MISSING A PART?
Please call our TOLL FREE
SERVICE CENTER
1 [phone]
TIP! FIRST, REMOVE PAINT FROM BARREL BOLT HOLES. Because the powder coat finish applied at
the factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be diffi-
cult. Therefore, before connecting parts, we recommend that you check to see that bolts slip easily through
all holes. If they do not, carefully clear paint from holes in side bars, ends and arms using a small knife.
SECOND, be certain that barrel nuts and bolts screw together easily BEFORE beginning assembly. Resi-
due from the black finish may cause some bolts to stick a bit, therefore use the two hex wrenches enclosed
(one for each end of the barrel) and screw them together to clear away extra paint.
Item No. Description Qty. Item No Description Qty.
3A Side bar 22” 4 thru holes 2 25B Pot hook angled 6
4A Oval end 2
Installation Hardware
5 Hang tab 2 15 1" S-hook 2
6 Curved arm 4 17 Trim Ceiling Cover 2
7D Grid Bracket 4 31X Flange Nut for Trim Cover 2
8E Oval Grid 12" x 32" 1 19A 1/4" x 4" Bolt Hook 2
28A Barrel Bolt 11 20 Wood Screw Hook - 4" 2
28B Barrel Nut 11 26A 1/4" Hex Wrench 2
25A Pot hook straight 6 27A 1/4" Toggle 2
31X