Installation Guide

8
Attach it to the wall.
Remove the controller’s cover from the base.
Locate the 4 mounting locations on the base.
Attach the base to the wall using the included
screws. Wall anchors are included for drywall.
Wire it up.
Insert sprinkler wire through the opening
on the base. Connect the wires to the
corresponding terminal locations. Press down
on each terminal tab with a screwdriver to
easily insert or remove each wire.
Connect the power cord.
Insert the power connector into the
controller’s power port in the lower right hand
corner of the wiring bay. Finally, plug the
transformer into a wall outlet.
Install
2