User Manual

ManualsBrandsRacercube ManualsHobbyIntegrated F3 EVO 4 In 1 20A F396 ESC Frsky 8CH PPM/SBUS Receiver for X Racing Frame

RacerCube Manual

Connection Diagram

Racercube FEATURES

F3_EVO FLIGHT CONTROLLER Jaw-Dropping Flight Performance

CLEANFLIGHT/BETAFLIGHT support

4IN1 ESC Little BEE 20A F396 Chip ESC Ready, BLHELI Pass-through Ready

FRSKY Compatible RX-F802 D8 MODE SBUS/PPM RECEIVER Ready

MWOSD Ready

RSSI/ VOLTAGE DETECOTR Ready

BUZZER READY

Summary of content (4 pages)

PAGE 1
RacerCube Manual Connection Diagram Racercube FEATURES F3_EVO FLIGHT CONTROLLER Jaw-Dropping Flight Performance CLEANFLIGHT/BETAFLIGHT support 4IN1 ESC Little BEE 20A F396 Chip ESC Ready, BLHELI Pass-through Ready FRSKY Compatible RX-F802 D8 MODE SBUS/PPM RECEIVER Ready MWOSD Ready RSSI/ VOLTAGE DETECOTR Ready BUZZER READY
PAGE 2
SPECFICTAION: 1.Racercube Flight controller Firmware: Cleanflight 1.13.0 Target: SP RACING F3 EVO STM32F303 CPU, 72Mhz inc FPU MPU9250 accelerometer/gyro/compass (connected via SPI) BMP280 barometer Compatible PPM/CPPM/SBUS/DSM2/DSMX Receiver Built-in MW OSD Integrate PDB support 2s-6s Input 2.Racercube Receiver module Channel: 8 Working voltage: 4-6.5V Frequency range: 2400-2483.
PAGE 3
Receiver configuration in Cleanflight: Enable Seria_RX for UART2 and Set Receiver mode RX_SERIAL ,Select SBUS in Cleanflight or Betaflight Configurator. Binding procedure: Power for the Racercube while holding the binding button, the green LED will getting to be solid, this indicate the receiver is in binding mode Turn on the transmitter and set the receiver mode to D8 mode , then move to ENT, press it and the transmitter beeps. The green LED will turn off once the binding procedure successfully.
PAGE 4
RSSI and Telemetry A1/A2 Voltage detector , RSSI After binding successful, turn on the transmitter ,move to the option TELEMETRY, then click “Discover new sensors” Set Screen to show the Telemetry info 2.Racercube 4in1 ESC module F396 MCU, 48Mhz Runs BLHELI LittieBee Pro 20A firmware Support 3-6S Li-po 4PWM input, Supports oneshot PWM Only 35x35mm, mount holes 30x30mm (on new batch, the holes will bechanged to 30.5x30.