Instruction manual

- 4 -
12/06/09
OLED Display Manual
OLED Setup
Video VBOX Pro / LITE / Waterproof
When setting up the DSP04 OLED display with a Video VBOX, it is
important to connect to the correct port of the OLED display. The OLED
display only has a serial connection on the lower connector, with the
buttons on the right hand side - as shown in this picture.
The configuration is indicated on a label on the rear of the OLED display.
To connect to a Video VBOX Lite, you should connect the cable into the
‘AUX’ port.
To connect to a Video VBOX Pro, you should connect the cable into the ‘SER’ port.
Note: For older 2CAM Video VBOX units – use the ‘DATA’ port.
To connect to a Video VBOX Waterproof, you should connect the cable into the ‘SER’ port.
VBOX Micro/ Performance Box Sport
As with the Video VBOX, the serial connector must be used when connecting to these units.
VBOX3i/ VBOX3/ VBSX/SL
Connection to the OLED display from any of these units can be made to either port on the OLED.