Instruction manual

- 11 -

12/06/09

OLED Display Manual

One Shot Mode

This mode is used for timing from a standing start to a finish line – e.g. sprint racing, hill climbs.

When one shot mode is enabled, when the user comes to a stop, after 2s, the screen counts down from 5 then

shows ARMED – Start when ready.

If the user pulls away before 1 is shown on the screen, nothing changes. During or after 1 is shown, when the user

pulls away the lap time measurement is started as if they had crossed a start/finish. If a lap had been running up to

this point, the time is discarded. After correct movement has been detected and a one shot start has started, a

normal start/finish line cannot be triggered for 3 seconds.

Set Start & Splits

After the  button is pressed a new start/finish point is set. The OLED will then show “Set split 1”. Press  to set the

split, ▼to skip, ▲ to go back. If a new start/finish or split line is set then the lap count, best lap and all the best split

time values automatically reset.

Press

After

Countdown

Stop

Vehicle

Press

Press to tick

option, then Exit