User guide

Racelogic Ltd DriftBox Tools
Software
- 79 -
Creating a Custom Acceleration test
1. Click on the Custom option in the Accel test drop down
list. This will then open the following window:
2. Enter the speed of the start condition.
3. Set the end condition option, speed or distance.
4. Enter a value for the chosen End condition.
5. Press Scan to scan the loaded file and produce a table
of results for all tests fitting the custom test setup.
Producing Deceleration Results
Deceleration data can be produced and shown in a results table from the
currently loaded data file by selecting one of the deceleration test options within
the „Decel results‟ drop down menu. Click on the „Decel results‟ button to open a
list of the following options:
 70-0 kmh: This will output the time and distance taken to decelerate from an initial
speed of 70 kmh to 0 kmh.
 50-0 kmh: This will output the time and distance taken to decelerate from an initial
speed of 50 kmh to 0 kmh.
 Custom: This will output the time and distance taken to decelerate from one user
definable initial speed to another, e.g. 100 kmh – 0 kmh.
In all of the Decel tests if more than one run is performed an average distance is also calculated
and shown.
Any of the Runs on the table can be omitted from the average by deselecting the tick in the use
box.
Creating a Custom Deceleration test
1. Click on the Custom option in the Decel
test drop down list. This will then open
the following window:
2. Enter the speed of the start condition
3. Set the speed of the end condition.
4. Press Scan to scan the loaded file and
produce a table of results for all tests
fitting the custom test setup.