User guide

Racelogic Ltd DriftBox Tools
Software
- 70 -
Result in the Graph window:
The main run is in red, the compare run in blue. In this instance the two laps have been performed
very consistently: the peaks and troughs, which indicate the braking and acceleration points, sit on
top of each other almost every time.
Note that the Graph window‟s X axis is set to distance – this makes direct comparison of braking
and acceleration points possible as the distance covered on each lap will be virtually identical. If
comparison laps are loaded when the Graph window‟s X axis is set to time, the data is very much
more difficult to analyse.
Result in the Graph:Map window:
Note how in this instance, the driver‟s lines have barely
deviated between the two laps – the main run in red is
only just visible below the compare run in blue.
Three compare laps can be loaded in total, allowing for
comparison of four laps at once (the main run plus
compare runs 1, 2, and 3.) Each compare lap will have
corresponding data displayed in an individual column in
the Graph:Data window. To change the colours of each
run, open the Channel Setup window and pick the
colours required from the Run x columns.
Loading and comparing individual laps from
different files
Lap data created by individual users, and therefore not logged in one .dbn file, can also be loaded
and compared:
 Load the first file containing the lap data, set the start / finish line, and click the lap timing
button. The laps will appear in the results window.