User guide

Racelogic Ltd Upgrading Firmware
- 42 -
Setup Menu
There is a single Setup Menu that is accessible in all of the DriftBox‟s modes.
To access the Setup Menu, press the MENU button in any mode and select the „SETUP‟ option
and press OK
The Setup Menu contains the following options:
SETUP MENU
LOGING MODE
PREDICTIVE MODE
COMMS MODE
SPEED BUZZERSPEE
ALIGNMENT
CONTRAST
BRIGHTNESS
DIAGNOSTICS
COLDSTART
UPGRADE
EXIT
Logging Mode
Allows the logging mode of the DriftBox to be configured, see the Data logging section of this
manual for more information.
Predictive Mode
Press „OK‟ to enable Predictive Mode. Note, if Predictive Mode is enabled, DriftMode and Power
Mode are disabled.
Alignment
The alignment option allows you to perform a physical alignment of the internal motion sensors. It
is important that you align DriftBox correctly whenever it is moved to a new position in your car or
even to another car. To do this, park the vehicle on level ground and turn the engine off and select
„ALIGNMENT‟ from the SETUP MENU. Reposition DriftBox so that the two cursors form a small
cross at the centre of the larger cross.
The two cursors do not have to line up perfectly, just make sure „ALIGNMENT OK‟ appears.
Contrast & Brightness
Use these to adjust the Brightness & Contrast of the screen, OK to return.