User guide

Racelogic Ltd Power Mode
- 39 -
Input Module Screen
The Input Module screen provides the ability to configure the input and output channels of a
connected Micro Input Module and view the data on each of the input module channels.
NB: This mode requires the RS232 chip upgrade in order to function.
Input module connection
The DriftBox connects to a Micro Input Module using an RLCAB094 cable plugged into the
Auxiliary connector on the back of the DriftBox to the DATA socket on the Micro Input Module. If
an input module is connected to a DriftBox then it will automatically log all of the input module
channels to the SD card.
Initialising the Micro Input module.
For DriftBoxes with firmware older than 3.0.17, In order for the unit to log the input module data
channels, the Input Module screen must be accessed whilst the input module is connected and the
DriftBox has satellite lock. After the Input Module screen has been accessed the screen will briefly
display the following message.
Then the screen will display the data output diagnostic screen. Once this has happened the
DriftBox will log the input module data. In firmware revision 1.4.76 and above a new display can be
accessed by pressing down in this mode.
This screen displays Speed and a selected input module channel. To select an input module
channel press the MENU button then navigate through the list to select display channel. From this
screen any one of the MICIN01 channels can be selected.
NOTE: After each power up, the Input Module Screen on the DriftBox must be accessed in order
for the DriftBox to recognise the presence of the MICIN01. After this has been done, then any of
the DriftBox screens can be used, but this must be done or the MICIN01 channels will not be
logged.
Configuring the Inputs and Outputs
See the Micro Input Module user guide for a full explanation of configuring the inputs and outputs
of a Micro Input Module.