User guide

Racelogic Ltd Predictive Mode
- 32 -
Predictive Mode
Predictive mode enables you to graphically view your predicted lap time. Predictive lap timing
works by saving your position around a circuit, every second. If the current lap is the fastest so far,
then this positional data is saved as a reference. With just one button push of an arrow key, you
are able to set a start/finish line within predictive mode. Please Note; this will overwrite a start/finish
line set in Laptiming mode.
By default, Predictive Mode is disabled. However, the user can enable Predictive Mode via the
setup menu or pressing ok while viewing the mode screen.
This message on screen means the DriftBox is receiving positional data from less than three
satellites.
If the DriftBox loses satellite lock while predicting, this screen will appear. The user will have wait
until the start finish line is crossed before predicting again.
Before Predictive mode can operate, you will need a reference lap. If a reference lap file is found
on the SD card as the Drift Box boots up, it will be automatically be loaded. A reference lap file can
be loaded from the SD card at any time using the Load Reference menu option. The Drift Box will
display this screen when no reference lap is available. Once a Reference lap has been set, the
Drift Box will start predicting when the start line has been crossed.
If you do not have a reference lap file, you will have to wait until a full lap of the circuit has been
completed. This screen will be displayed while the DriftBox is creating a reference lap