User guide

Racelogic Ltd Laptiming Mode
- 28 -
 When this screen shows you can then start your lap. Timing of your lap will start as soon as
you pull away and will then stop as you cross the start / finish line at the end of your flying
lap.
Start / finish and split lines
Before DriftBox can measure and display times, you will need to either load previously recorded
start / finish lines or create new ones in your DriftBox. This is done using either Simple Lap Timing,
mentioned above, which sets only a start / finish line. In order to set a start / finish AND split points,
follow the instructions below.
Setting start / finish lines
 Press the MENU button to display the Lap Timing Menu.
 Highlight „SET START & SPLITS‟ and press OK
 As you drive across the start / finish line press OK
 This will set the start / finish line and the screen will now show the SET SPLIT1 screen.
 To set the first Split, press OK when you pass this point or press RESET to skip.
 If you wish just to place a separate Finish line, press the „RESET’ button to skip all the split
points and scroll to the SET 2
nd
FINISH screen.
 Press OK to set a separate finish line as you drive over it.
Note: you must be moving to be able to set virtual lines.
Saving start / finish and Split Lines
After creating start / finish, Splits or Finish lines you can save them to a file on the SD card which
can be loaded back into DriftBox at a later stage, or used in the VBox Tools software. The file
created is called DBOX.DSF and is saved into the „DATA‟ directory on the SD card. If a
DBOX.DSF already exists the file will not be created; this is to prevent existing start and split lines
being accidentally overwritten.