User guide

Racelogic Ltd Performance Mode
- 21 -
Measuring the 0-60 time of your vehicle
1. Install DriftBox into your vehicle as described in the „Quick Start Guide‟ section of this
manual.
2. Press the MODE button to select the Performance Mode.
3. Now use the ▲▼ buttons to scroll to the ACCEL screen. This screen shows 0-60 in
the top right hand corner:
4. The left hand side of the screen shows your live velocity unless you are in an area of
poor satellite reception in which case it flashes “LOW SATS”.
5. Now perform your 0-60 acceleration run. As your vehicle goes over 60 mph the time will
instantly show in the 0-60 section of the window.
6. If you come to a stop you will see that this time remains on view. The Vmax section will
also show the highest speed you attained during this particular run:
7. You can now instantly start another 0-60 acceleration, as you pull away the screen will
reset and show your new values as you cross 60 mph.
8. After doing a number of runs you can view your best 0-60 time by scrolling to the BEST
screen.
9. If you have your SD card inserted then your run data will be stored.
Please note, to record a results file, you must accelerate over at least 30 Km/H.