User guide

Racelogic Ltd Performance Mode
- 19 -
Performance Mode
The Performance mode is used to measure the acceleration and braking performance of your
vehicle. Press the MODE button to scroll to the Performance Mode screen. This mode is divided
into six screens, each of which displays different performance data. Navigate between these
screens by using the▲▼buttons. Each screen will automatically display the results as they
happen, e.g. if you drive from 0 Mph to 60 Mph then the 0-60 section will show the time taken.
Below is a list of the available Performance Mode display screens.
This Acceleration Screen displays a live velocity in the left half and
in the right it shows the times of the following pre-set test ranges.
0 to 60, 0-100 and 0-100-0.
It also shows the maximum speed.
Acceleration 2 screen shows the 30-50 and 50-70 times. However
these two test ranges are user adjustable through the setup menu.
Peak lateral g (cornering force) is also shown along with an
average velocity value.
The next screen shows the times required to reach various speeds
from rest. The target speeds are every 10 km/h or mph
(depending on the units selected), up to a speed of 100 km/h /
mph.
This screen continues the readings of the previous screen, listing
the speeds from 110 to 200 km/h / mph.
This screen shows the best results of the two test ranges from
each of the acceleration screens.
This screen shows the time and distance of two user adjustable
deceleration ranges. These test ranges can be configured in the
setup menu.
This screen shows the same information as the previous
Deceleration screen, but for a different user-defined speed range.