User guide

Racelogic Ltd Drift Mode
- 15 -
Drift Mode
Drift Mode is used to measure your drifting ability, showing current and maximum drift angles and
give a grading of your performance as a score between 0 and 10 points. Scores can be sent to the
DriftBox website for publishing on the Top Scores database.
By default, Drift Mode is enabled however when Predictive mode is enabled, Drift Mode becomes
disabled.
On a fully activated DriftBox an SD card can be inserted to log your scores and data from your runs
that can then be downloaded and viewed on your computer and in the DriftBox Tools PC software.
The Drift Mode can be used in two different ways; Sectors and Practice. The default is Practice,
but you can turn on Sectors in the Drift Menu.
Practice
Without Sectors enabled, the DriftBox measures a single run at a time, where a run is defined as
anything larger than 5
o
of drift and a speed greater than 25Km/h. The run finishes when you go
below these thresholds. You can then see Peak Drift angle, speed at which that drift angle
occurred, the peak Lateral G during the run and the overall Score which is based on Lateral G and
Drift Angle.
Sectors
When Sector Mode is selected, a run starts at one virtual gate and finishes at another, see the
„Sectors‟ section later on for more details.
Selecting Sector Mode
To set DriftBox to Sector mode
 In Drift Mode, press MENU
 Select „Sectors‟ then press the OK button.
DRIFT MENU
UNITS
 SECTORS
SET SECTORS
CLEAR SECTORS